CX65 CX65 new FW12 and DCA-510

[majes]

After I upgrade firmware to FW12 I can't connect with my cx65 via dca-510 :(

Have you got the same problem?

[Wert]

I use DCA-500 and there is no such problem but I have read in other forums that there are indeed problems with USB connectivity.

[oakdesign]

no i didn't have the problem with the dca 510 i only had to set connectivity speed at the device manager to 57600

[majes]

i only had to set connectivity speed at the device manager to 57600

hmm, i did it but still i can't connect with phone...

help me :?

[hilmi01]

I had the same problem. Plug in the DCA-510, start MPM, switch off your mobile, switch on your mobile, now MPM should find your mobile. This fixed my problem, I hope yours too.

[majes]

it doesn't help me :(
any other ideas?

[hilmi01]

Try to change connectivity speed. It should work with 9600.

Check your COM-Configuration. Sometimes the DCA-510 takes a COM-Port which is used by another Hardware.

[majes]

Try to change connectivity speed. It should work with 9600.


yeah, now it works - thx